AR-1U1000 1 Watt CW, 10 KHz - 1000 MHz
FREQUENCY RESPONSE: 10kHz to 1000 MHz
RATED OUTPUT POWER: 1 W minimum
INPUT FOR RATED OUTPUT: 0 dBm maximum
POWER OUTPUT @ 3dB COMPRESSION:
- Typical: 1.5 watts, Minimum: 1.0 watt
POWER OUTPUT @ 1dB COMPRESSION:
- Typical: 1.5 watts, Minimum: 1.0 watt
FLATNESS:
- ±0.8 dB typical
- ±1 dB maximum
GAIN: 30 dB minimum
INPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 maximum
OUTPUT IMPEDANCE: 50 ohms, nominal
MISMATCH TOLERANCE: 100% of rated power without foldback. Will operate without damage or oscillation with any magnitude and phase of source and load
impedance. See Application Note #27.
MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal
HARMONIC DISTORTION: Minus 20 dBc maximum at 1 watts
THIRD ORDER INTERCEPT POINT: 42 dBm typical
The Model 1U1000 is a solid-state, self contained, air-cooled, broadband amplifier designed for applications where instantaneous bandwidth, high gain and linearity are required. Housed in a stylish, contemporary cabinet, the unit is designed for benchtop use.
The Model 1U1000, when used with a sweep generator, will provide a minimum of 1 watt of RF power. Included is a front panel gain control, which permits the operator to conveniently set the desired output level.
The 1U1000 is protected from RF input overdrive by an RF input leveling circuit, which controls the RF input level to the RF amplifier first stage when the RF input level is increased above 0dBm. The Model 1U1000 is equipped with a control panel, which provides a gain control adjustment knob.
The Model 1U1000 provides readily available RF power for typical applications such as RF susceptibility testing, antenna and component testing, wattmeter calibration, and as a driver for frequency multipliers and higher power amplifiers.
The Model 1U1000 is a solid-state, self contained, air-cooled, broadband amplifier designed for applications where instantaneous bandwidth, high gain and linearity are required. Housed in a stylish, contemporary cabinet, the unit is designed for benchtop use.
The Model 1U1000, when used with a sweep generator, will provide a minimum of 1 watt of RF power. Included is a front panel gain control, which permits the operator to conveniently set the desired output level.
The 1U1000 is protected from RF input overdrive by an RF input leveling circuit, which controls the RF input level to the RF amplifier first stage when the RF input level is increased above 0dBm. The Model 1U1000 is equipped with a control panel, which provides a gain control adjustment knob.
The Model 1U1000 provides readily available RF power for typical applications such as RF susceptibility testing, antenna and component testing, wattmeter calibration, and as a driver for frequency multipliers and higher power amplifiers.