AR-100A400A 100 Watt CW, 10 kHz - 400 MHz (w/ IEEE-488, RS-232, USB, Ethernet & Fiber Optic interfaces)
FREQUENCY RESPONSE: 10 kHz to 400 MHz instantaneously
RATED OUTPUT POWER: 130 W typical, 100 W minimum
INPUT FOR RATED OUTPUT: 0 dBm maximum
POWER OUTPUT @ 1dB COMPRESSION
- Nominal: 85 W
- Minimum: 75 W
FLATNESS:
- ±1.0 dB typical, ±1.5 dB maximum
GAIN: 50 dB minimum
INPUT IMPEDANCE: 50 ohms, VSWR 2.0:1 maximum
OUTPUT IMPEDANCE: 50 ohm nominal
MISMATCH TOLERANCE:
100% of rated power without foldback. Will operate without damage or oscillation with any magnitude and phase of source and load impedance. See Application Note #27.
MODULATION CAPABILITY: Will faithfully reproduce AM, FM, or pulse modulation appearing on the input signal
NOISE FIGURE: 8 dB typical
HARMONIC DISTORTION:-20 dBc maximum at 75 W; -30 dBc typical at 50 watts
THIRD ORDER INTERCEPT POINT: 55 dBm typical
Remote Interfaces:
- IEEE-488, 24 pin female
- RS-232, 9 pin Subminiature D (female)
- Fiber Optic, ST Conn Tx and Rx RS-232
- USB 2.0, Type B
- Ethernet, RJ-45
The Model 100A400A is a solid-state, self-contained, air-cooled, broadband amplifier designed for applications where instantaneous bandwidth, high gain and linearity are required. Available in a stylish, contemporary cabinet for benchtop use or with cabinet removed for rack mounting.
The Model 100A400A , when used with a sweep generator, will provide a minimum of 100 watts of RF power. Included is a front panel gain control, which permits the operator to conveniently set the desired output level. The 100A400A is protected from RF input overdrive by an RF input leveling circuit, which controls the RF input level to the RF amplifier first stage when the RF input level is increased above 0dBm.
The RF amplifier stages are protected from over-temperature by removing the DC voltage to them if an overtemperature condition occurs due to cooling blockage or fan failure. The front panel indicates the operate status and fault conditions if an over-temperature or power supply fault has occurred. The unit can be returned to operate when the condition has been cleared.
All amplifier control functions and status indications are available remotely through the optional Remotes Package. The Remotes Package includes GPIB/IEEE-488 format, RS-232 hardwire and fiber optic, USB, and Ethernet.
The Model 100A400A is a solid-state, self-contained, air-cooled, broadband amplifier designed for applications where instantaneous bandwidth, high gain and linearity are required. Available in a stylish, contemporary cabinet for benchtop use or with cabinet removed for rack mounting.
The Model 100A400A , when used with a sweep generator, will provide a minimum of 100 watts of RF power. Included is a front panel gain control, which permits the operator to conveniently set the desired output level. The 100A400A is protected from RF input overdrive by an RF input leveling circuit, which controls the RF input level to the RF amplifier first stage when the RF input level is increased above 0dBm.
The RF amplifier stages are protected from over-temperature by removing the DC voltage to them if an overtemperature condition occurs due to cooling blockage or fan failure. The front panel indicates the operate status and fault conditions if an over-temperature or power supply fault has occurred. The unit can be returned to operate when the condition has been cleared.
All amplifier control functions and status indications are available remotely through the optional Remotes Package. The Remotes Package includes GPIB/IEEE-488 format, RS-232 hardwire and fiber optic, USB, and Ethernet.